Failure reasons of skew opening and crease of box gluing machine:analysis of skew of box gluing machine

After the paperboard comes out of the paper conveying mechanism, due to the inconsistent friction between the two groups of transmission belts leaning against the body and facing outward and the paperboard, the paperboard is skewed during transmission between the belts. The reasons  of skew opening and crease of box gluing machine are as follows.

1.One of the failure reasons of skew opening and crease of box gluing machine is the different tension of the two groups of belts close to the body and facing outward of the box gluing machine, the stress on both ends of the paperboard is uneven,causing skew tension.

Solution: adjust the eccentric height with hexagon socket, so as to change the tension of the corresponding belt.

2.Furthermore,one of the failure reasons of skew opening and crease of box gluing machine is that the locking mechanism of the upper and lower belts is not pressed down or not pressed in place (such conditions often occur for novices), resulting in excessive upper and lower spacing of a group of belts.

Solution: standardize the operation and carefully check whether the locking mechanism is in place.

3.In addition, The transmission belt slips or falls off due to aging and other reasons are also the failure reasons of skew opening and crease of box gluing machine.

Solution: carefully check the locking mechanism of the belt, appropriately reduce the speed of the box pasting machine, and replace the aged belt in time.

Failure reasons of skew opening and crease of box gluing machine:the phenomenon of  creases skew of box gluing machine

During the pre folding process, the paperboard is folded without pressing the mark line, causing the skew of paperboard folding. Failure reasons of skew opening and crease of box gluing machine are as follows.

1.The indentation line is too wide or unclear, leading to the skew of pre folding.

Solution: due to the indentation line cannot be changed, it can only be made up by adjusting the pre folding guide rod.

2. The position of the pre folding guide rod is improperly adjusted or not fixed firmly, leading to the skew of pre folding.

Solution: generally, the pre folding guide rod is adjusted for several times, and it is locked after checking that the crease is accurate.

3. The tightness of the transmission belts on both sides is inconsistent, resulting in the skew of the paperboard and the skew of the folding.

Solution: adjust the tightening mechanism of the belt to eliminate the skew of the paperboard.

These are the failure reasons of skew opening and crease of box gluing machine.Having a good command of the failure reasons of skew opening and crease of box gluing can help you solve the problem quikly.