1.Feed section. It is composed of paper feeding belt, main front gauge, auxiliary front gauge, side baffle, paper feeding speed, belt roller and paper stack back baffle.

(1)The components of folding and gluing machine:feed belt

The tension of the paper feeding belt should be even and equal, and tight enough to prevent the belt from sliding on the drive shaft. According to the carton size, use as many belts as possible.

(2) The components of folding and gluing machine: main front gauge

The main front gauge must be on a certain paper feeding belt, and then the position of the main front gauge should be determined according to the cardboard box. The following principles should be observed: the main front gauge should be placed between the first and the third crease as far as possible; As far as possible to make the main front gauge automatically close to the middle of the cardboard box; The main front gauge should be placed opposite the longest front board and the widest board as far as possible. The height of the main front gauge should be adjusted according to the thickness of the paperboard to ensure that the paperboard can pass freely, but there should be no gap. The electronic double sheet detection system is used to control the appearance of double sheet.

(3) The components of folding and gluing machine: vice front gauge

The function of the auxiliary front gauge is to further support the paper stack at the front to prevent the paper stack from falling down due to the gap between the side baffles. The height of the auxiliary front gauge is generally 3 times of the thickness of the paperboard.

(4) The components of folding and gluing machine: side baffle

When adjusting the side baffle, it should be avoided that the paperboard is too crowded between the two side baffles. Generally, a gap of 1-2mm should be left.

(5) The components of folding and gluing machine: feed speed

The paper feeding speed of the paper pasting machine is adjusted by the CVT. Pay attention not to use the CVT when the machine is stopped.

(6) The components of folding and gluing machine:Belt roller

The pressure roller of the conveyor belt can make the paperboard align against the side baffle to ensure the correct position of the side of the paperboard.

(7) The components of folding and gluing machine: the back baffle of the stack

The function of the stack back baffle is to tilt the stack slightly for paper feeding.