Empty Sheet in Flexo Folder Gluer

Flexo Folder Gluer is the last process of carton forming, which has a crucial decision for the quality of products. In addition, for operators, it is also a test, experienced operators can effectively improve the quality and efficiency of production. So how to deal with the problem of empty sheet in the actual operation of flexo folder gluer?

The empty sheet problem of the flexo folder gluer is caused by many factors, and the common reasons are as follows:

1. The quality of the cardboard itself is too light, or curled, too much paper powder, etc., will cause the phenomenon of empty sheets.

Solution: Just increase the weight of the paper, or arrange the cardboard, and at the same time flatten the cardboard and shake off the paper powder.

2. The quality of the paperboard is too light, the pile is not high enough, the operator did not put the paperboard, resulting in the equipment friction is not enough and empty.

Solution: Just need the operator to add cardboard regularly.

3. The angle of the support rod of the flexo folder gluer is too high, resulting in the paperboard can not be in good contact with the equipment, resulting in the phenomenon of empty tension.

Solution: Just adjust the height of the support rod and keep it at an appropriate height.

4. Due to the aging of the belt of the flexo folder gluer, the belt slips.

Solution: Only need to roughen the belt, increase its surface roughness, or increase the jet device can solve this problem.