Maintenance of High Speed Automatic Folder Gluer

1. The operation interface of the automatic folder gluer machine must be kept clean and cleaned frequently.

2. Wipe the mechanical belt with clean water to keep it clean to prevent slipping, especially to prevent sticking to the belt.The rubber wheel and box on the bottom of the hook must be cleaned after work every day, otherwise the glue in the box will freeze and affect the gluing effect.

3. The glue box should be kept clean and scrubbed frequently.

4. It is strictly forbidden to adjust the speed when the governor is stopped, otherwise the belt wear will be severe.

5. The inner plate support, shaft and rod should be cleaned regularly, and the lubricating oil and butter should be mixed together. The effect is better. It can be shaken left and right to prevent rust.

6. It’s better to drive slowly before starting the machine to check whether the machine is abnormal.

Safety Operation Regulations of High Speed Automatic Folder Gluer

1. Operation preparation

(1) Receiving the construction order and confirming the semi-finished products.

(2) Stack semi-finished products correctly and neatly.

(3) Run the machine slowly to see if the belt and other parts are working normally.

(4) Adjust the amount of glue according to the width of the paper.

 2. Operation process

(1) Do a good job of plate installation according to product requirements.

(2) If there is a problem with the indentation line, stop the machine and contact the relevant department.

(3) Slow rotation to see if the running material is normal, until normal before acceleration.

(4) In case of a box with a bottom lock, the bottom lock hook must be installed correctly.

(5) Adjust the box forming pressure according to the product structure.

 3. End of operation

(1) Write the daily report. (2) Cleaning up the surrounding area. (3) Tidy up the pile of paper. (4) Turn off the main power supply.